RAD DATA COMMUNICATIONS CMN-C11 Card Type Modem (asynchronous) Chipset Unidentified Maximum Data Rate 19.2Kbps Data Modulation Unidentified Data Bus Proprietary [Image] CONNECTIONS Function Label Function Label Serial data port CN1 Loopback test switch SW4 Telephone line out CN2 USER CONFIGURABLE SETTINGS Setting Label Position Front panel switch may initiate remote JP1 Pins 1 & 2 loopback test closed Front panel switch may not initiate JP1 Pins 3 & 4 remote loopback test closed Stop bit shortening for asynchronous mode SW1/1 Off set to 12.5% Stop bit shortening for asynchronous mode SW1/1 On set to 25% DCD forced high SW1/4 On DCD follows RTS SW1/4 Off Pin 18 of CN1 has no function SW1/5 Off Pin 18 of CN1 begins local analog SW1/5 On loopback test Pin 21 of CN1 has no function SW1/6 Off Pin 21 of CN1 begins remote digital SW1/6 On loopback test CN1 is DCE SW3 Off CN1 is DTE SW3 On RTS TO CTS DELAY SELECTION Setting JP2/A JP2/B JP2/C 0 mS Closed Open Open 8 mS Open Closed Open 68 mS Open Open Closed DATA LENGTH SELECTION Setting SW1/2 SW1/3 8 bits Off Off 9 bits Off On 10 bits On Off 11 bits On On LINE SPEED SELECTION Setting SW2 1200bps Position 7 2400bps Position 6 3600bps Position 5 4800bps Position 4 7200bps Position 3 9600bps Position 2 14.4Kbps Position 1 19.2Kbps Position 0 DIAGNOSTIC LED(S) LED Color Status Condition PWR Green On Power is on PWR Green Off Power is off XMT Yellow On Modem is transmitting data XMT Yellow Off Modem is not transmitting data RCV Yellow On Modem is receiving data RCV Yellow Off Modem is not receiving data DCD Yellow On Carrier signal detected DCD Yellow Off Carrier signal not detected TST Red On Modem is in test mode TST Red Off Modem is not in test mode MISCELLANEOUS TECHNICAL NOTE This card is intended for use in the CMN-16 rack-mount system. The bus is used only for supplying power for the card. All other card functions are accessed through the serial port.